Report of the Chief of the Massachusetts District Police

Forside
Massachusetts District Police, 1915
 

Innhold

Del 1
48
Del 2
225
Del 3
226
Del 4
227
Del 5
229
Del 6
230
Del 7
231
Del 8
232
Del 10
234
Del 11
236
Del 12
237
Del 13
238
Del 14
241
Del 15
242
Del 16
243
Del 17
265

Del 9
233
Del 18
284

Andre utgaver - Vis alle

Vanlige uttrykk og setninger

Populære avsnitt

Side 111 - See that the entire installation is in accordance with the rules of the National Board of Fire Underwriters...
Side 274 - In order to determine if the material conforms to the chemical limitations prescribed in paragraph No. 2 herein, analysis shall be made of drillings taken from a small test ingot.
Side 82 - ... the mayor and aldermen of a city or the selectmen of a town in which there is no such board.
Side 274 - The variation in cross-section or weight of more than 2} per cent from that specified will be sufficient cause for rejection, except in the case of sheared plates, •which will, be covered by the following permissible variations...
Side 273 - For other material the test specimen may be the same as for sheared plates, or it may be planed or turned parallel throughout its entire length, and in all cases where possible two opposite sides of the test specimen shall be the rolled surfaces.
Side 19 - Lord's day which shall be in keeping with the character of the day and not inconsistent with its due observance...
Side 275 - For all plates ordered to gauge, there will be permitted an average excess of weight over that corresponding to the dimensions on the order, equal in amount to that specified in the following table: TABLE OF ALLOWANCES FOR OVERWEIGHT FOR RECTANGULAR PLATES WHEN ORDERED TO GAUGE.
Side 110 - ... 3. That such supply of air will so circulate in the rooms that no uncomfortable draught will be felt, and that the difference in temperature between any two points on the breathing plane in the occupied portion of a room will not exceed 3°.
Side 31 - No cinematograph, or similar apparatus, involving the use of a combustible film more than ten inches in length, shall be kept or used...
Side 255 - The maximum strength of rivets per square inch of cross-sectional area shall be taken as follows : Pounds Iron rivets in single shear 38,000 Iron rivets in double shear 76.

Bibliografisk informasjon