An Introduction to Mensuration and Practical Geometry

Forside
Kimber & Sharpless, 1835 - 288 sider
 

Hva folk mener - Skriv en omtale

Vi har ikke funnet noen omtaler på noen av de vanlige stedene.

Andre utgaver - Vis alle

Vanlige uttrykk og setninger

Populære avsnitt

Side 119 - A sphere is a solid figure described by the revolution of a semicircle about its diameter, which remains unmoved.
Side 7 - The square of the sum of two numbers is equal to the square of the first number plus twice the product of the first and second number plus the square of the second number.
Side 88 - ... 11.701 ft. 74. A right-angled triangle has its base 16 rods, and its perpendicular 12 rods, and a triangle is cut off from it by a line parallel to its base, of which the area is 24 rods. Required the sides of that triangle. Ans. 8, 6, and 10 rods. 75. There is a circular pond whose area is 5028f square feet, in the middle of which stood a pole 100 feet high ; now, the pole having been broken off, it was observed that the top portion resting on the stump just reached the brink of the pond. What...
Side 20 - In a right-angled triangle, the side opposite to the right angle, is called the hypothenuse ; and the other two sides are called the legs, and sometimes the base and perpendicular : thus, A, B is the base, B, C perpendicular, and A, C hypothenuse.
Side 78 - When the quotient arising from the versed sine divided by the diameter, has a remainder or fraction after the third place of decimals ; having taken the area...
Side 19 - Parallel straight lines are such as are in the same plane, and which, being produced ever so far both ways, do not meet.
Side 21 - The circumference of every circle is supposed to be divided into 360 equal parts, called degrees ; each degree into 60 equal parts, called minutes ; and each minute into 60 equal parts, called seconds.
Side 260 - MECHANICAL POWERS are certain simple instruments employed in raising greater weights, or overcoming greater resistance than could be effected by the direct application of natural strength. They are usually accounted six in number; viz. the Lever, the Wheel and Axle, the Pulley, the Inclined Plane, the Wedge, and the Screw.
Side 54 - To find the area of a rectangular board, whose length is 12-^ feet, and breadth 9 inches. Ans. 9f feet.
Side 96 - As the conjugate diameter is to the transverse, So is the square root of the difference of the squares of the ordinate and semi-conjugate, To the distance between the ordinate and centre.

Bibliografisk informasjon