Report of the Chief of the Massachusetts District Police

Forside
Massachusetts District Police, 1913
 

Hva folk mener - Skriv en omtale

Vi har ikke funnet noen omtaler på noen av de vanlige stedene.

Innhold

Andre utgaver - Vis alle

Vanlige uttrykk og setninger

Populære avsnitt

Side 50 - ... five years, one for four years, one for three years, one for two years, and one for one year, and thereafter as the terms of office expire in each year one member for a term of five years.
Side 44 - States, shall be thoroughly inspected internally and externally at intervals of not over one year, and shall not be operated at pressures in excess of the safe working pressure stated in the certificate of inspection hereinafter mentioned, which pressure is to be ascertained by rules established by the board of boiler rules...
Side 25 - No person shall exhibit or operate any cinematograph or similar apparatus involving the use of a combustible film more than ten inches in length until he has received a license so to do from an inspector of the district police.
Side 21 - Any person keeping, using or exhibiting a cinematograph or other similar apparatus contrary to the provisions hereof, or in violation of any rule or regulation made by the...
Side 160 - No. 2 herein, analysis shall be made of drillings taken from a small test ingot. An additional check analysis may be made from a tensile specimen of each melt used on an order other than in locomotive fire-box steel. In the case of locomotive fire-box steel a check analysis may be made from the tensile specimen from each plate as rolled. VARIATION IN WEIGHT.
Side 43 - Every employer shall post in a conspicuous place in every room where such minors are employed a printed notice, stating the hours required of them each day of the week, the hours of commencing and stopping work and the hours when the time or times allowed for dinner or for other meals begin and end.
Side 160 - For all plates ordered to gauge, there will be permitted an average excess of weight over that corresponding to the dimensions on the order, equal in amount to that specified in the following table: TABLE OF ALLOWANCES FOR OVERWEIGHT FOR RECTANGULAR PLATES WHEN ORDERED TO GAUGE.
Side 158 - For other material the test specimen may be the same as for sheared plates, or it may be planed or turned parallel throughout its entire length, and in all cases where possible two opposite sides of the test specimen shall be the rolled surfaces.
Side 42 - Laws, or of section forty-two of chapter five hundred and fourteen of the acts of the year nineteen hundred and nine...
Side 41 - Section one of chapter six hundred and forty-nine of the acts of the year nineteen hundred and eleven is hereby amended by striking out the said section, and inserting in place thereof the following: — Section 1.

Bibliografisk informasjon